RAM Mounts Form-Fit Halteschale (Schlüsselverriegelung) für Honeywell ScanPal EDA10A Tablet in OEM-Schutzhülle - 5.5mm DC & USB-A-Anschluss

This RAM Mounts Form Fit (key-locking) holder is suitable for the Honeywell ScanPal EDA10A Tablet in OEM protective boot.
The holder is powered by a 5.5mm DC connection and charges the device in the dock while peripheral support is provided by the built-in USB Type-A cable.

To insert the device, place the bottom of the device in the cradle and press it into the cradle until it clicks into position.
The cut-outs on the buttons and ports allow you to continue using them without any problems.
The cradle also allows the tablet's scanning function to continue to be used because of the cutout at the back.

RAM Vent-Temp utilizes the vehicle's vents to direct hot or cold air to the Honeywell ScanPal EDA10A.
An RAM NFC add-on module can be used to extend the device's internal NFC reader.

The back of the device holder is prepared to support a VESA 75x75 mm or round ball base (not included).

Product features RAM Mounts RAM-HOL-HON11PDKLU:

• Compatible with OEM hand strap
• Easy insertion and removal
• Charging function
• Lockable with key
• Prepared for RAM NFC Extender & RAM Vent-Temp
• 2-Hole side mount (Diamond ball base) for additional devices or peripheral accessories
• Input Connector: 5.5mm DC-Connector
• Input Voltage: 5V
• Output Connector: USB-A 2.0 (Peripheral output - 500mAh)
• Transferspeed: 12Mbps
• Input Cable Length: ca. 100 cm
• Output Cable Length: ca. 25 cm
• Certifications: RoHS, WEEE, CE & FCC

Additional information:
Devices shown are not included in the delivery.

Only the RAM-HOL-HON11PDKLU holder is supplied.