RAM Mounts Form-Fit Halteschale (mit Schlüsselverriegelung) für Zebra ET80 & ET85 2-in-1 Tablets (mit/ohne Rugged Boot & Tastatur) - 5.5mm Stromanbindung & Dual USB-A Datenanbindung - AMPS 4-Loch Aufnahme - VESA 75x75 - Schrauben-Set

This RAM Mounts Form-Fit (key-locking) holder is suitable for Zebra ET8x 2-in-1 Tablet with or without Rugged Boot and Keyboard.
The holder is powered by a 5.5mm DC connection and charges the device in the dock while peripheral support is provided by the built-in Dual USB Type-A cable.

To insert the device, place the bottom of the device in the cradle and press it into the cradle until it clicks into position.
The cut-outs on the buttons and ports allow you to continue using them without any problems.

The cut-out on the inside of the cradle allows tablet accessories such as Zebra Expansion Back, GDS Roto-Mag and GDS Hand-Stand to be used here as well.

The RAM Temp-Right™ can be added for thermal regulation in extremely cold environments, while the RAM Vent-Temp™ utilizes the vehicle's vents to direct hot or cold air to the ET8x.

An NFC repeater add-on module can be used to extend the device's internal NFC reader.

The back of the device holder is prepared to support a VESA 75x75 mm or round ball base (not included).

Product features RAM Mounts RAM-HOL-ZE22PD2LU:

• Compatible with accessories
• Easy insertion and removal
• Additional mounting plate for attaching additional devices or accessories
• Usable with RAM Vent-Temp, Temp-Right or NFC-Repeater
• Lockable with Keys
• Input Connector: 5.5mm DC-Connector
• Output Connector: 2x USB-A 2.0 (Peripheral output - 900mAh)
• Transfer Speed: 12Mbps
• Input Cable Length: ca. 100 cm
• Output Cable Length: ca. 24 cm
• Certifications: RoHS, WEEE, CE & UKCA

Additional information:
Devices shown are not included in the delivery.

Only the RAM-HOL-ZE22PD2LU holder is supplied.